A practical reference on single-use aliquot: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2026-06-05 and is reviewed periodically as new material appears.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Semax is a synthetic peptide created in the Soviet Union during the early 1980s by researchers working in Moscow. It was built from the short adrenocorticotropic hormone fragment known as ACTH(4-10), and the chain was then extended with three additional amino acids. The resulting molecule was named semax and entered clinical use in Russia in 1994. It is generally described as a nootropic and neuroprotective agent rather than as a hormone analogue.
The parent fragment ACTH(4-10) carries the sequence Met-Glu-His-Phe-Arg-Trp-Gly. Semax replaces the arginine and tryptophan positions with a proline-glycine-proline tail, giving Met-Glu-His-Phe-Pro-Gly-Pro. That change removes residues associated with adrenal stimulation, so the peptide does not drive cortisol release the way full ACTH does. This distinction shapes how the compound is grouped in the literature, where it sits with neuropeptides and peptide neuromodulators rather than with corticosteroids.
Regulatory status varies sharply by country. Semax is registered for medical use in Russia, where it appears in formularies as a nasal solution, and it also holds registration in a small number of neighbouring states. It has no approval from the United States Food and Drug Administration or the European Medicines Agency, and it is not a scheduled controlled substance in most jurisdictions. Elsewhere it circulates mainly as laboratory material, so purity documentation comes from suppliers rather than from a national pharmacopoeia.
| Property | Value | Notes |
|---|---|---|
| Solid storage temperature | -20 °C or below | Desiccated and protected from light |
| Solution storage temperature | -80 °C as single-use aliquots | Avoid repeated freeze-thaw cycles |
| Purity assessment method | RP-HPLC, around 214 nm | Reported as main-peak area percent |
| Identity confirmation method | ESI-MS or MALDI-TOF | Measured mass compared with calculated mass |
| Common synonyms | ACTH(4-10) analog; Met-Glu-His-Phe-Pro-Gly-Pro | Also written as Semaxum in some sources |
溶液状态的稳定性明显低于冻干粉。肽类在水溶液中可能经历水解、氧化与聚集，其中甲硫氨酸和天冬酰胺等残基常是敏感位点。Semax 含有甲硫氨酸，因此氧化风险相对突出。工作液一般主张现配现用，或冷藏并在数日内用尽。缓冲液种类、pH 和离子强度都会影响降解速率，而关于最佳条件的公开数据并不统一。
常规纯度与身份确认依赖反相高效液相色谱，并辅以质谱测定分子量。氨基酸组成分析可用于验证序列构成，肽图分析则能进一步定位修饰或降解产物。杂质谱通常关注缺失序列肽、截短片段和氧化产物。不同方法的检出限并不相同，因此各实验室报告的纯度数值不宜直接横向比较。
多数实验室与市售的 Semax 以冻干粉形式提供。冻干粉通常建议保存在 -20 °C 或更低温度下，同时避免光照与反复升温。短期运输有时采用冷藏条件，但长期保存仍以冷冻为主。分包操作应尽量减少开盖次数，以降低吸湿和微生物污染的风险。开封后若未一次用完，建议在干燥环境中密封并尽快放回低温储存。
各国监管态度分化明显。俄罗斯按处方药管理，部分东欧国家留有使用记录；欧盟与美国未批准其作为药物上市，市面流通品通常标注为研究用化学品。身份差异意味着标示含量、纯度与无菌性缺少统一核查。体育领域还牵涉反兴奋剂名录，跨境携带则受目的地药品法规约束。
Semax 是人工设计的七肽，序列为 Met-Glu-His-Phe-Pro-Gly-Pro，骨架取自促肾上腺皮质激素片段 ACTH(4-10)。它于二十世纪八十年代在苏联的分子遗传学研究机构内合成。设计目标是保留该片段与注意力和记忆相关的活性，同时剔除促皮质激素释放等内分泌作用。此后俄罗斯将其登记为药品并进入临床使用。
当时的短肽研究普遍关注能否穿越血脑屏障、在低剂量下产生中枢效应，Semax 属于这一路线。鼻内给药是其主要使用方式，俄语文献报道的适应症涵盖缺血性卒中、短暂性脑缺血发作、认知功能减退以及视神经病变。这些研究大多发表在当地期刊上，样本规模与终点设置同西方试验惯例存在差异，国际同行对其临床证据的强度看法不一。
Routine characterization relies on reversed-phase high-performance liquid chromatography to establish purity and on mass spectrometry to confirm molecular identity. Electrospray ionization and matrix-assisted laser desorption ionization are both used for mass verification. Amino acid analysis and peptide mapping can detect sequence errors. Common impurities include truncated sequences, methionine sulfoxide formed by oxidation, and deamidated products. Chromatograms are usually recorded near 214 nm, where the peptide backbone absorbs, and purity is reported as the percentage area of the principal peak.
Verification of a supplied batch generally combines a certificate of analysis with independent testing, because certificates are self-reported documents. A typical package includes a chromatographic trace, a mass spectrum, and a stated water or counter-ion content. Batch-to-batch consistency matters more than a single purity figure when results are compared across experiments. No single mandatory standard governs research-grade peptide release, so laboratories are expected to define their own acceptance criteria. Residual trifluoroacetate from purification is a frequently overlooked counter-ion.
In medicine, oxygen saturation, commonly referred to as "sats", measures the percentage of hemoglobin binding sites in the bloodstream occupied by oxygen. At low partial pressures of oxygen, most hemoglobin is deoxygenated. At around 90% (the value varies according to the clinical context) oxygen saturation increases according to an oxygen-hemoglobin dissociation curve and approaches 100% at partial oxygen pressures of >11 kPa. A pulse oximeter relies on the light absorption characteristics of saturated hemoglobin to give an indication of oxygen saturation.
For example, if the first residue is a phenylalanine then the enzyme chymotrypsin will cleave at site 1, and if the third residue of the tripeptide is a lysine then trypsin would cleave at the third cleavage site.
Most members of the MMP family are organized into three basic, distinctive, and well-conserved domains based on structural considerations: an amino-terminal propeptide; a catalytic domain; and a hemopexin-like domain at the carboxy-terminal. The propeptide consists of approximately 80–90 amino acids containing a cysteine residue, which interacts with the catalytic zinc atom via its side chain thiol group. A highly conserved sequence (. . .PRCGXPD. . .) is present in the propeptide. Removal of the propeptide by proteolysis results in zymogen activation, as all members of the MMP family are produced in a latent form. The catalytic domain contains two zinc ions and at least one calcium ion coordinated to various residues. One of the two zinc ions is present in the active site and is involved in the catalytic processes of the MMPs. The second zinc ion (also known as structural zinc) and the calcium ion are present in the catalytic domain approximately 12 Å away from the catalytic zinc. The catalytic zinc ion is essential for the proteolytic activity of MMPs; the three histidine residues that coordinate with the catalytic zinc are conserved among all the MMPs. Little is known about the roles of the second zinc ion and the calcium ion within the catalytic domain, but the MMPs are shown to possess high affinities for structural zinc and calcium ions.
Sources: en.wikipedia.org
The Humboldt party departed Mexico City on January 20, 1804, heading for Puebla and Veracruz, taking with them a wealth of scientific material and observations. On March 7, 1804, Humboldt departed from Veracruz, sailing to Havana to recover the scientific collections he had stored there more than three years earlier for safekeeping. Previously, when Humboldt attempted to join Baudin in Lima, it appeared he had abandoned any intention of traveling to the northern regions of the American continent. In late November 1802, he wrote to the Institut National in Paris, stating his hope to return to Europe through Mexico and Cuba by the following autumn. In his letter, Humboldt emphasized his focus on preserving and publishing his manuscripts and expressed a strong desire to be in Paris. However, his decision to delay his return and visit the United States emerged at the last moment. This change was likely inspired by his deep admiration for the American President, Thomas Jefferson, whom Humboldt felt compelled to meet before leaving the New World. His interest was further heightened by curiosity about Jefferson’s initiatives for exploring the American West.
Within the mesh scaffolding of bat wing skin, collagen fibers cross bones perpendicular to the long axes of the bones, therefore mechanical properties of bat wing skin oriented perpendicular to the long axes of the bones exhibit a lower stiffness than the skin that is oriented parallel to the long axes of the bodies. Stiffer skin is necessary for bat wing skin oriented in the direction parallel to the long axes of the bones to prevent too much deformation of bat wing skin during flight (with respect to the bone), resulting in the shearing of the bat wing skin off of the bone. Flexible skin is necessary for the direction perpendicular to the long axes of the bones for facilitating the shape changes needed for movement and control during flight. This anisotropy of bat wing skin is also useful as method of storing and releasing elastic energy, particularly during the downstroke. During the downstroke, the bat extends its wing and the wing skin experiences an aerodynamic force. The wing skin expands and counteracts the aerodynamic force. After the wing is fully extended, the orientation of the wing is nearly vertical and the aerodynamic forces on the wing are reduced. As the aerodynamic force is reduced, the wing recoils, drawing the digits of the wings together in preparation for the upstroke.
Almost all patients develop oliguria or anuria within a few hours to as late as 6 days post bite. In some cases, kidney dialysis is necessary due to acute kidney injury, but this is not often caused by hypotension. It is more often the result of intravascular hemolysis, which occurs in about half of all cases. In other cases, ARF is often caused by disseminated intravascular coagulation.
The Rhodesian Bush War, a guerrilla conflict between the government and two rival communist-backed black Rhodesian groups, began in earnest two years later, and after several attempts to end the war Smith concluded the Internal Settlement with non-militant nationalists in 1978. Under these terms the country was reconstituted under black rule as Zimbabwe Rhodesia in June 1979, but this new order was rejected by the guerrillas and the international community. The Bush War continued until Zimbabwe Rhodesia revoked its UDI as part of the Lancaster House Agreement in December 1979. Following a brief period of direct British rule, the country was granted internationally recognised independence under the name Zimbabwe in 1980.
Sources: en.wikipedia.org
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.
A high main-peak percentage says little about identity, counter-ion content, or residual solvents. It also does not distinguish an isomer or a closely eluting analog. Mass confirmation and the accompanying documentation cover those gaps.
Salt form changes mass, solubility, and hygroscopicity, and acetate and trifluoroacetate salts behave differently in solution. Storage guidance still centers on -20 °C for powder and lower temperatures for solutions. The certificate should state which salt is present.
Registered medical products are most often 0.1% nasal drops. Research suppliers ship lyophilized powder, usually in milligram quantities, which is dissolved before use. The active peptide is the same in both cases; presentation and excipients differ.