A practical reference on counter-ion: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
Reviewed 2026-01-23. Anything still debated is marked as such rather than presented as settled.
Common degradation pathways include oxidation of the methionine side chain, hydrolysis of the peptide backbone, and aggregation under unfavourable pH or concentration. Stability studies typically monitor the main peak by chromatography and report total related substances as a percentage. Because no official monograph exists, acceptance criteria vary between laboratories, and reported purity values are not directly comparable across suppliers. Analysts therefore document the method, column, and detection wavelength alongside each result, and open questions remain about how much biological activity the oxidised forms retain.
Solid semax is typically supplied as a lyophilised powder that is hygroscopic and sensitive to moisture, light, and repeated temperature cycling. Long-term storage of the dry peptide is generally recommended at approximately -20 degrees Celsius, while shorter working periods may use refrigeration at 2 to 8 degrees Celsius. Vials should remain tightly closed and desiccated when brought to room temperature, because condensation can damage the material before it is weighed. Dividing a batch into aliquots is preferable to thawing one container repeatedly.
Dissolution is normally performed in water, phosphate-buffered saline, or normal saline, since the peptide is freely soluble in aqueous media and is rarely handled with strong organic solvents. Solution pH should be kept near neutral, because extreme acidity or alkalinity accelerates backbone hydrolysis and encourages oxidation of the methionine side chain. Once dissolved, the material is less stable than the dry powder and is commonly divided into single-use portions and frozen. Buffers containing primary amines, such as Tris, are often avoided because of possible side reactions.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
| Property | Value | Notes |
|---|---|---|
| Typical analytical method | Reversed-phase HPLC with UV detection | Separates target peptide from truncated and oxidised forms |
| Identity confirmation | LC-MS or ESI-MS | Compares observed and calculated molecular ion |
| Primary degradation route | Methionine oxidation | Forms the sulfoxide; monitored as an early-eluting peak |
| Short-term storage | 2 to 8 degrees Celsius | Applies to working vials and reconstituted portions |
| Common synonyms | ACTH(4–10) analogue, MEHFPGP | Descriptive names used in laboratory catalogues |
Lyophilized material is chemically stable for extended periods when kept dry, cold, and protected from light. The powder is hygroscopic, so vials should be warmed to room temperature before opening to reduce condensation on the contents. Once dissolved, the peptide is far less stable because peptide bonds are susceptible to hydrolysis and the methionine residue can oxidize. Solutions are typically aliquoted and held at 2-8 °C for short intervals or frozen for longer ones, and repeated freeze-thaw cycles should be avoided.
Routine characterization relies on reversed-phase high-performance liquid chromatography to establish purity and on mass spectrometry to confirm molecular identity. Electrospray ionization and matrix-assisted laser desorption ionization are both used for mass verification. Amino acid analysis and peptide mapping can detect sequence errors. Common impurities include truncated sequences, methionine sulfoxide formed by oxidation, and deamidated products. Chromatograms are usually recorded near 214 nm, where the peptide backbone absorbs, and purity is reported as the percentage area of the principal peak.
Verification of a supplied batch generally combines a certificate of analysis with independent testing, because certificates are self-reported documents. A typical package includes a chromatographic trace, a mass spectrum, and a stated water or counter-ion content. Batch-to-batch consistency matters more than a single purity figure when results are compared across experiments. No single mandatory standard governs research-grade peptide release, so laboratories are expected to define their own acceptance criteria. Residual trifluoroacetate from purification is a frequently overlooked counter-ion.
从分子层面看，Semax 是线性七肽，没有二硫键、糖基或脂链修饰，N 端为游离氨基，C 端为游离羧基。分子含组氨酸与谷氨酸侧链，因此在水和甲醇等极性溶剂中溶解良好，在非极性溶剂中溶解有限。计算分子量约为 814 Da，与其质子化离子的质荷比吻合，可用于质谱确认。
稳定性主要由水解与氧化两条路径支配。肽键在中性或弱酸性条件下相对稳定，遇到强碱或长时间高温则明显断裂；甲硫氨酸侧链容易被氧化成亚砜，使主峰前移并拉低实际含量。金属离子、光照和反复冻融会进一步促进降解或聚集。冻干粉在低温避光条件下可存放较长时间，配制后的水溶液通常需要冷藏并尽快用完。
纯度评估以反相高效液相色谱为主，通过主峰面积百分比给出粗略结果，再配合电喷雾质谱核对分子量。氨基酸分析可验证组成比例，手性色谱或毛细管电泳用于检查残基构型。常见杂质包括缺失序列的短肽、氧化产物与二聚体。由于多数市售品不附带完整检验报告，独立第三方检测常被用来核实标称值。
Following the ban on Sufi orders in the Republic of Turkey, the Bektashi community's headquarters was moved from Hacıbektaş in central Anatolia, to Tirana, Albania. In Albania, the Bektashi community declared its separation from the Sunni community and they have since perceived as a distinct Islamic sect rather than a branch of Sunni Islam. Among the most famous followers of Bektashi in Balkans during the 19th century were Ali Pasha of Yanina and Naim Frashëri.
==== Media, social, internal and foreign affairs ==== Defense, National Security and Emergency Committee Diplomatic and Consular Affairs Committee Public Freedoms and Human Rights Committee Media Committee Social Affairs and Labor Committee Youth and Sports Committee Family and Women Committee Endowments, Religious Affairs and Fatwa Committee
In June 1976, scientists from the Scripps Institution of Oceanography obtained the first evidence for submarine hydrothermal vents along the Galápagos Rift, a spur of the East Pacific Rise, on the Pleiades II expedition, using the Deep-Tow seafloor imaging system. In 1977, the first scientific papers on hydrothermal vents were published by scientists from the Scripps Institution of Oceanography; research scientist Peter Lonsdale published photographs taken from deep-towed cameras, and PhD student Kathleen Crane published maps and temperature anomaly data. Transponders were deployed at the site, which was nicknamed "Clam-bake", to enable an expedition to return the following year for direct observations with the DSV Alvin. Chemosynthetic ecosystems surrounding the Galápagos Rift submarine hydrothermal vents were first directly observed in 1977, when a group of marine geologists funded by the National Science Foundation returned to the Clambake sites. The principal investigator for the submersible study was Jack Corliss of Oregon State University. Corliss and Tjeerd van Andel from Stanford University observed and sampled the vents and their ecosystem on February 17, 1977, while diving in the DSV Alvin, a research submersible operated by the Woods Hole Oceanographic Institution (WHOI). Other scientists on the research cruise included Richard (Dick) Von Herzen and Robert Ballard of WHOI, Jack Dymond and Louis Gordon of Oregon State University, John Edmond and Tanya Atwater of the Massachusetts Institute of Technology, Dave Williams of the U.S.
=== Performing arts === The Coastal Credit Union Music Park at Walnut Creek hosts major international touring acts. In 2011, the Downtown Raleigh Amphitheater opened (now sponsored as the Red Hat Amphitheater), which hosts numerous concerts primarily in the summer months. An additional amphitheater sits on the grounds of the North Carolina Museum of Art, which hosts a summer concert series and outdoor movies. Nearby Cary is home to the Koka Booth Amphitheatre which hosts additional summer concerts and outdoor movies, and serves as the venue for regularly scheduled outdoor concerts by the North Carolina Symphony based in Raleigh. During the North Carolina State Fair, Dorton Arena hosts headline acts. The private Lincoln Theatre is one of several clubs in downtown Raleigh that schedules many concerts throughout the year in multiple formats (rock, pop, country). The Duke Energy Center for the Performing Arts complex houses the Raleigh Memorial Auditorium, the Fletcher Opera Theater, the Kennedy Theatre, and the Meymandi Concert Hall. In 2008, a new theatre space, the Meymandi Theatre at the Murphey School, was opened in the restored auditorium of the historic Murphey School. Theater performances are also offered at the Raleigh Little Theatre, Long View Center, Ira David Wood III Pullen Park Theatre, and Stewart and Thompson Theaters at North Carolina State University.
Sources: en.wikipedia.org
=== G04CA Alpha-adrenoreceptor antagonists === G04CA01 Alfuzosin G04CA02 Tamsulosin G04CA03 Terazosin G04CA04 Silodosin G04CA51 Alfuzosin and finasteride G04CA52 Tamsulosin and dutasteride G04CA53 Tamsulosin and solifenacin G04CA54 Tamsulosin and tadalafil G04CA55 Doxazosin and finasteride
===== First generation ===== The Cronin–Gerow Implant, prosthesis model 1963, was a silicone rubber envelope-sac, shaped like a teardrop, which was filled with viscous silicone-gel. To reduce the rotation of the emplaced breast implant upon the chest wall, the model 1963 prosthesis was affixed to the implant pocket with a fastener-patch, made of Dacron material (polyethylene terephthalate), which was attached to the rear of the breast implant shell.
Cleavage takes place in two steps: first, the 3’,5’-phosphodiester bond is cleaved to generate a 2’,3’-cyclic phosphodiester intermediate; second, the cyclic phosphodiester is hydrolyzed to a 3’-monophosphate. It can be inhibited by ribonuclease inhibitor protein, by heavy metal ions, and by uridine-vanadate complexes.
Sources: en.wikipedia.org
Dry powder is usually kept at about -20 degrees Celsius for long-term storage and at 2 to 8 degrees Celsius for short working periods. Containers should stay sealed and protected from light and moisture to limit degradation.
Oxidation of the methionine residue to the sulfoxide is a frequently reported change, and it usually appears as an earlier-eluting peak in reversed-phase chromatography. Backbone hydrolysis products can also accumulate in aqueous solution.
Liquid chromatography coupled with mass spectrometry is the usual approach, because the observed molecular ion can be compared with a calculated mass of about 813.9 Da. Retention time alone does not establish identity.
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.