If you have been reading about ACTH(4-10) and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Last reviewed on 2026-05-08. Where a claim depends on a specific study, the study is described rather than over-claimed.
多数实验室与市售的 Semax 以冻干粉形式提供。冻干粉通常建议保存在 -20 °C 或更低温度下，同时避免光照与反复升温。短期运输有时采用冷藏条件，但长期保存仍以冷冻为主。分包操作应尽量减少开盖次数，以降低吸湿和微生物污染的风险。开封后若未一次用完，建议在干燥环境中密封并尽快放回低温储存。
溶液状态的稳定性明显低于冻干粉。肽类在水溶液中可能经历水解、氧化与聚集，其中甲硫氨酸和天冬酰胺等残基常是敏感位点。Semax 含有甲硫氨酸，因此氧化风险相对突出。工作液一般主张现配现用，或冷藏并在数日内用尽。缓冲液种类、pH 和离子强度都会影响降解速率，而关于最佳条件的公开数据并不统一。
常规纯度与身份确认依赖反相高效液相色谱，并辅以质谱测定分子量。氨基酸组成分析可用于验证序列构成，肽图分析则能进一步定位修饰或降解产物。杂质谱通常关注缺失序列肽、截短片段和氧化产物。不同方法的检出限并不相同，因此各实验室报告的纯度数值不宜直接横向比较。
The parent fragment ACTH(4-10) carries the sequence Met-Glu-His-Phe-Arg-Trp-Gly. Semax replaces the arginine and tryptophan positions with a proline-glycine-proline tail, giving Met-Glu-His-Phe-Pro-Gly-Pro. That change removes residues associated with adrenal stimulation, so the peptide does not drive cortisol release the way full ACTH does. This distinction shapes how the compound is grouped in the literature, where it sits with neuropeptides and peptide neuromodulators rather than with corticosteroids.
Regulatory status varies sharply by country. Semax is registered for medical use in Russia, where it appears in formularies as a nasal solution, and it also holds registration in a small number of neighbouring states. It has no approval from the United States Food and Drug Administration or the European Medicines Agency, and it is not a scheduled controlled substance in most jurisdictions. Elsewhere it circulates mainly as laboratory material, so purity documentation comes from suppliers rather than from a national pharmacopoeia.
| Property | Value | Notes |
|---|---|---|
| 外观 | 白色至类白色粉末 | 常见于冻干制剂 |
| 溶解度 | 易溶于水 | 在极性溶剂中一般也可溶 |
| 建议储存温度 | -20 °C | 冻干粉，避光密封 |
| 常见分析手段 | 反相高效液相色谱 | 常与质谱联用 |
| 主要降解路径 | 水解与氧化 | 溶液状态更显著 |
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
Development of the compound took place in the Soviet Union during the 1980s, largely through peptide research groups affiliated with the Shemyakin-Ovchinnikov Institute and Moscow State University. Investigators screened fragments of adrenocorticotropic hormone for activity on the central nervous system while attempting to separate cognitive effects from hormonal ones. The shortened sequence was selected because it retained behavioral activity in animal models without stimulating corticosteroid release. Early publications described the molecule as an ACTH(4-10) analog.
Published research on this peptide originates mainly from Russian laboratories, and the wider international literature is comparatively thin. Studies have used rodent models of stroke, hypoxia, and memory tasks, with a smaller number of human trials reported. Reported outcomes include changes in attention and memory measures, along with effects on neurotrophic factor expression in some experiments. Small sample sizes, inconsistent dosing protocols, and limited independent replication are widely noted limitations, so the strength of the clinical evidence remains an open question.
Semax is a synthetic heptapeptide whose sequence is Met-Glu-His-Phe-Pro-Gly-Pro. The first four residues correspond to the ACTH(4-10) fragment, while the terminal Pro-Gly-Pro extension was added to improve metabolic stability. Its molecular formula is C37H51N9O10S and its monoisotopic mass is approximately 813.9 Da. The compound is classified as a peptide research chemical and as a registered pharmaceutical product in Russia, but it does not hold marketing approval in the European Union or the United States. Naming conventions vary across supplier catalogs.
Pharmacokinetic accounts emphasize rapid breakdown. After intravenous dosing the intact peptide disappears from blood within minutes, and nasal delivery produces low but measurable concentrations. Metabolites rather than the parent molecule may account for part of the observed activity, although the relative contribution is unresolved. Dosing in the literature varies widely and no optimal schedule has been agreed. These gaps are regularly cited as a reason the findings have not produced broad clinical adoption beyond the original research setting.
Proposed mechanisms center on neurotrophic signaling rather than on classical melanocortin receptor activation. Rodent experiments have reported shifts in the expression of brain-derived neurotrophic factor and nerve growth factor after administration, together with changes in the associated receptor systems. Several authors argue that the peptide acts largely through its degradation products and their interaction with peptidergic pathways, but this remains a hypothesis rather than a settled finding. No single molecular target has been identified in a way that the field broadly accepts.
Published research covers ischemic stroke, traumatic brain injury, cognitive impairment, optic nerve conditions and attention-related measures. Much of the human evidence comes from small trials conducted in one country, which limits how far the results generalize. Animal models supply the larger share of the data, and effects seen in rodents do not transfer automatically to people. Reviews have noted that methodological reporting is often incomplete, making it difficult to pool results or compare treatment schedules across studies.
This phenomenon was used in the design of light meters and similar devices. Selenium's semiconductor properties found numerous other applications in electronics. The development of selenium rectifiers began during the early 1930s, and these replaced copper oxide rectifiers because they were more efficient. These lasted in commercial applications until the 1970s, following which they were replaced with less expensive and even more efficient silicon rectifiers. Selenium came to medical notice later because of its toxicity to industrial workers. Selenium was also recognized as an important veterinary toxin, which is seen in animals that have eaten high-selenium plants. In 1954, the first hints of specific biological functions of selenium were discovered in microorganisms by biochemist, Jane Pinsent. It was discovered to be essential for mammalian life in 1957. In the 1970s, it was shown to be present in two independent sets of enzymes. This was followed by the discovery of selenocysteine in proteins. During the 1980s, selenocysteine was shown to be encoded by the codon UGA. The recoding mechanism was worked out first in bacteria and then in mammals (see SECIS element).
The metabolism of drugs is often divided into the following three phases. Phase I: modification, phase II: conjugation, and phase III: excretion. These phases act in concert to detoxify drugs and remove them from cells and eventually from the body. The purpose of phase I is to introduce polar groups that either themselves directly facilitate excretion or to create reactive functional groups. These reactive groups can be conjugated in a phase II reaction with molecules that are recognized by transport proteins. In the last step, transport proteins eliminate the drug conjugate from the body. In phase I, enzymes such as Cytochrome P450 oxidases introduce reactive or polar groups into xenobiotics. These modified compounds are then conjugated to polar compounds in phase II reactions. These reactions are catalyzed by transferase enzymes such as glutathione S-transferases. Finally, in phase III, the conjugated xenobiotics may be further processed, before being recognized by efflux transporters and pumped out of cells. Drug metabolism often converts lipophilic compounds into hydrophilic products that are more readily excreted.
== External links == Pathway at biocarta.com Nosek, Thomas M. "Section 6/6ch2/s6ch2_34". Essentials of Human Physiology. Archived from the original on 2016-03-24. Overview of all the structural information available in the PDB for UniProt: P01282 (VIP peptides) at the PDBe-KB.
Myelofibrosis can be a late complication of other myeloproliferative disorders, such as polycythemia vera, and less commonly, essential thrombocythemia. In these cases, myelofibrosis occurs as a result of somatic evolution of the abnormal hematopoietic stem cell clone that caused the original disorder. In some cases, the development of myelofibrosis following these disorders may be accelerated by the oral chemotherapy drug hydroxyurea.
Sources: en.wikipedia.org
With increased concerns about nuclear waste, breeding fuel cycles came under renewed interest as they can reduce actinide wastes, particularly plutonium and minor actinides such as neptunium, americium and curium. Breeder reactors are designed to fission the actinide wastes as fuel and thus convert them to more fission products. For unreprocessed uranium-oxide spent nuclear fuel, Bodansky's 2006 review described a rapid initial decrease in radioactivity as short-lived fission products decay, followed by a more gradual decrease as actinides decay. Today's commercial light-water reactors do breed some new fissile material, mostly in the form of plutonium. Because commercial reactors were never designed as breeders, they do not convert enough uranium-238 into plutonium to replace the uranium-235 consumed. Nonetheless, at least one-third of the power produced by commercial nuclear reactors comes from fission of plutonium generated within the fuel. Even with this level of plutonium consumption, light water reactors consume only part of the plutonium and minor actinides they produce, and nonfissile isotopes of plutonium build up, along with significant quantities of other minor actinides. Since breeder reactors on a closed fuel cycle would use nearly all of the isotopes of these actinides fed into them as fuel, their fuel requirements would be reduced by a factor of about 100. Waste volume alone does not determine disposal requirements. A 2023 DOE assessment identified radionuclide inventory, heat output, chemical and physical properties, and packaging as relevant factors.
Virtually all infections with rabies resulted in death until two French scientists, Louis Pasteur and Émile Roux, developed the first rabies vaccination in 1885. Nine-year-old Joseph Meister (1876–1940), who had been mauled by a rabid dog, was the first human to receive this vaccine. The treatment started with a subcutaneous injection on 6 July 1885, at 8:00 pm, which was followed with 12 additional doses administered over the following 10 days. The first injection was derived from the spinal cord of an inoculated rabbit which had died of rabies 15 days earlier. All the doses were obtained by attenuation, but later ones were progressively more virulent. After the rabies vaccine created by Louis Pasteur was first introduced in France in 1885, its use soon spread to other countries, including outside of Europe. The vaccine was first used in the United States in 1886. In 1888, France established the Pasteur Institute. During the following decades, several similar specialized rabies prevention centers ("Pasteur Institutes") appeared around the world. By 1909 there were 75 such rabies centers worldwide, including in French Indochina. Victims of animal bites in Siam were already receiving the rabies vaccine as early as 1891, becoming the first patients to receive it in Asia. By the late 19th century, European jurisdictions were regulating rabies treatment by opening their own rabies centers or by directing patients to the nearest centers abroad.
== Impact on function == Conservative replacements in proteins often have a better effect on function than non-conservative replacements. The reduced effect of conservative replacements on function can also be seen in the occurrence of different replacements in nature. Non-conservative replacements between proteins are far more likely to be removed by natural selection due to their deleterious effects.
Sources: en.wikipedia.org
一般不建议常温长期保存。多数说明指向 -20 °C 冷冻避光。常温运输通常被视为短期可接受，但会加快降解风险。
公开资料对此没有统一答案。普遍建议现配现用，或冷藏并在数日内用完。含甲硫氨酸的序列更易氧化，放置时间越长风险越高。
反相高效液相色谱是最常用的手段，配合质谱确认分子量。氨基酸组成分析和肽图分析可补充序列层面的验证。
Registered medical products are most often 0.1% nasal drops. Research suppliers ship lyophilized powder, usually in milligram quantities, which is dissolved before use. The active peptide is the same in both cases; presentation and excipients differ.